Fahrenheit To Celsius; Voltage Change Option (240V To 208V); Beep Volume; How To Obtain Service - Thermador CM301 Care And Use Manual

Doqt-Yourself Maintenance Built-in CHOven Care andUseManual
Do-It-Yourself Maintenance
Fahrenheit to Celsius
The oven has been preset to a Fahrenheit temperature.
To change to Celsius, follow these steps:
I. Turn off ovens.
2. Touch and hold the START pad and then the
CONVECTION pad at the same time for
3 seconds.
3. "F" appears in the temperature digits; release both
pads at the same time.
4. Touch CONVECTION; "C" replaces"F." This alternates
when CONVECTION is touched.
5. To complete the change, touch START.
Voltage Change Option
The oven has been preset for 240 VAC. If your residence
has been supplied with 208 VAC, the oven voltage can
be changed during installation.
1. Turn both ovens off. Touch OVEN OFF for each oven.
2. Touch and hold the START pad and the SELF CLEAN
pad at the same time for 3 seconds.
3. "240" appears in the display. Release both pads at
the same time.
4. Touch the SELF CLEAN pad. "240" is replaced with
"208/' This alternates when SELF CLEAN is touched.
5. To complete the change, touch START.
Calibrating Oven Temperature
The electronic thermostat has been preset to 0°F and
accurately maintains its setting. If the browning results
are too light or too dark for your preferences, you can
raise or lower the setting.
To change calibration of oven temperature for
single or upper ovens:
1. Turn off oven(s).
2. For single oven or upper oven, touch and hold the
START pad and then touch the BAKE pad.
3. "0" (zero) appears in the temperature digits; release
all pads at the same time.
4. Touch BAKE and 0 changes in increments of 5 degrees
each time it is touched. The maximum adjustment is
± 35oi:.
5. To complete the change, touch START.
To change calibration of oven temperature for lower
oven on double ovens:
1. Touch the ROAST pad.
2, Continue with Steps 3 through 5, as described above,
NOTE: The available temperature range for this
oven is 100°F to 550°1:. This applies to all
conventional cooking modes. A change in
the calibration does not affect Dehydrate,
Proof or Warm modes.
Beep Volume
The volume of the beeps can be adjusted. Touch and
hold the START pad followed by the PROBE pad for three
seconds. Touch PROBE pad again to increase or decrease
volume, from levels 1 to 3. Touch START to set volume
selection.
How to Obtain Service
For authorized service or parts information, phone (800) 735-4328.
We want you to remain a satisfied customer. If a problem occurs that cannot be resolved
to your satisfaction write to Thermador Customer Support Center,
555:[ NcFadden Avenue, Huntington Beach CA, 92649 or call: :[-800-735-4328.
Please include the Nodel Number, Serial Number, Fabrication Date and Date of Original
Purchase and Installation.
54