Tappan TGF645WFW3 Owner's Manual page 15

General Cleaning
(continued)
When lowering the top,
grasp the sides with fingertips only. Be
careful notto pinch fingers. Also, DO NOT
drop or bend the rangetopwhen raising or
lowering. This could damage the surface.
Hold cooktop flat to remove
J_" _Support
Ill,, .od
DO NOTturn the burners
on when the cooktop israisedfor cleaning.
Be surethat the top iscompletely lowered
and securely in place before turning on
the burners.
Use the finger openings along the
outside edges of the oven bottom to raise
and lower the oven bottom.
To Raise and Lower the Top for Cleaning
1. Remove burner grates and spillover bowls. Set aside.
2. Grasp the front of the cooktop and then lift.
3. Lift the top high enough to fully raise the support rods. The Lift-up rods will
support the top in its raised position.
4. Clean underneath using hot, soapy water and a clean cloth; then, dry.
5. Lower the top gently after lowering the support rod.
To Remove and Replace Burners for Cleaning
Your model will have one of the two burners types shown below. Follow the
instructions that correspond with the burners on your range.
Figure I
Bar
Figure 2
To Remove Burners (Figure 1)
I. Remove shipping screws with a Phillips® Head screwdriver. See illustration for
screw locations.
2. Tiltthe burner atthe end closesttothe support bar until the locator tab isreleased
(front burnerstilt right, rear burnerstilt left). Move it toward the back of the range.
This will separate it from the gas valve at the front of the range.
To Remove Burners (Figure 2)
I. Remove shipping screws with a Phillips® Head screwdriver. See illustration for
screw locations.
2. Lift burner pair straight up and out of range.
To Replace Burners (Figure 1)
I. Slide the burner tube over the gas valve at the front of the range (front burners
fit over the right valve, rear burners fit over the left valve on each side of the
range).
2. Tilt burner sothat the locating tab will slide intothe slot on the support bar. Make
sure burners are properly seated on support bar and are level.
3. Replace shipping screws if desired.
To Replace Burners (Figure 2)
I. Placeburner pair over mounting bracket. Make sure burners are positioned over
gas valves and are properly positioned and level.
2. Replace shipping screws if desired.
To Remove and Replace Oven Bottom
To Remove the Oven Bottom:
Using the finger openings on each side of the oven bottom, pull out and lift up the
oven bottom.
To Replace the Oven Bottom:
1. Grasp the oven bottom and position the front tabs in place in the slots at the rear
of the oven.
2. Lower the front of the oven bottom and slide into place.
15