Tuning; Direct Tuning; Automatic Tuning - Sony STR-DE545 Operating Instructions Manual

Direct Tuning Automatic Tuning
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 38.
1 Press
TUNER.
The last received station is tuned in.
2 Press FM/AM to select the FM or AM band.
3
Press D.TUNING on the remote.
4
Press the numeric buttons on the remote to enter
the frequency.
Example1: FM 102.50 MHz
© • ® .,. ® • ® o ®
Example2: AM 1350 kHz
(You don't have to enter the last "0" when the tuning interval
is set to 10 kHz)
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5 If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception,
6 Repeat Steps 2 to 5 to receive other stations.
(_ If you try to enter a frequencynot coveredby the tuning
interval
The entered value is automatically rounded up or down.
Tuning intervals for direct tuning are:
FM: 50 kHz
AM: 10 kHz (to change to 9 kHz, see page 48.)
For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 38.
1 Press TUNER.
The last received station is tuned in.
2
3
Press FM/AM to select the FM or AM band.
Press TUNING + or TUNING -.
Press the + button to scan from low to high; press the -
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4 To continue scanning, press TUNING + or TUNING -
again.
=0
m
m.
eL
39