Sony STR-DE545 Operating Instructions Manual page 19

I II
"_° About speaker distances
This receiver allows you to il_put timespeaker position in terms of
distance. However, it is not possible to set tbe center speaker
farther away than the front speakers. Also, the center speaker can
not be set more that 5 feet (1.5 meters) closer than the front
speakers.
Likewise, time rear speakers cannot he set farther away from the
listening position titan tbe front speakers. And they can be no
more than 15 feet (4.5 meters) closer.
This is because incorrect speaker placement is not conducive to
enjoy the surround sound.
Please note that, setting the speaker distance closer than the
actual location of the speakers will cause a delay in the output of
the sound from that speaker. In other words, the speaker will
sound like it is farther away.
For example, setting the center speaker distance 3-6 feet (1 ~2 m)
closer than tbe actual speaker position will create a fairly realistic
sensation of being "inside" the screen. If you cannot obtain a
satisfactory surround effect because the rear speakers are too
close, setting the rear speaker distance closer (shorter) than the
actual distance will create a larger soundstage. (1 foot
corresponds to a I ms difference.)
Adjusting these parameters while listening to the sound often
results in much better surround sound. Give it a try!
Adjusting the speaker volume
Use the remote while seated in your listening position to
adjust the volume of each speaker.
Note
This receiver incorporates a new test tone with a frequency
centered at 80(3 Hz for easier speaker volume adjustment.
1 Press I/_ to turn on the receiver.
2
3
4
Press TEST TONE on the supplied remote.
You will hear the test tone from each speaker in
sequence.
Adjust the volume level so that the volume of the
test tone from each speaker sounds the same
when you are in your main listening position.
• To adjust the balance of the front right and front 1eft
speakers, use the front balance parameter in the
LEVEL menu (see page 34).
• To adjust the balance of the rear right and rear left
speakers, use the rear balance parameter in the
LEVEL menu (see page 34).
• To adjust the volume level of the center speaker,
press MENU </> to select the center parameter.
Use +/- on the remote to adjust the level.
• To adjust the volume level of the rear speaker, press
MENU </> to select the rear parameter.
Use +/- on the remote to adjust the level.
Press TEST TONE on the remote again to turn off
the test tone,
Note
The test tone cannot be output when the receiver is set to 5.1CH
INPUT.
"_" You can adjust the volume level of all speakers at the same
time
Rotate MASTER VOLUME on the receiver or press MASTER
VOL +/- on the remote.
z
0
0
5'
"o
o.
¢D
c
t_
"0
x-
-i
t_
t_
3
19