Direct Tuning - Sony STR-DB930 Operating Instructions Manual

PRESET TUNING +/-
TUNING +/–
MEMORY FUNCTION
SHIFT FM MODE
FM/AM
Brief descriptions of buttons used to
receive broadcasts
PRESET TUNING +/-: Press to scan all preset radio
stations.
TUNING +/-: Press to scan all available radio stations.
FUNCTION control: Rotate to select the tuner.
FM MODE: If "STEREO" flashes in the display and the
FM stereo reception is poor, press this button to improve
the sound. You will not be able to enjoy stereo effect but
the sound will be less distorted.
Note
If "STEREO" does not appear at all even when the FM broadcast
is received normally, press this button to turn on the "STEREO"
indication.
FM/AM: Press to select the FM or AM band.
MEMORY: Uses for memorizing preset stations.
SHIFT: Press to select a memory page (A, B, or C) for
presetting radio stations or tuning to preset stations.
44
EEE SSS a ааа
Direct Tuning
Use the supplied remote to perform the following
operations.
For details on the buttons used in this section, see the
operating instructions for the supplied remote.
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2 Press FM/AM to select the FM or AM band.
3 Press D. TUNING.
4 Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz
CO •(0) •(2)+ (5)• (0)
Example 2: AM 1350 kHz
(You don't have to enter the last "0" when the tuning scale is
set to 10 kHz.)
(4) •(8)+(5)• (0)
If you cannot tune in a station and the
entered numbers fiash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5 If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6 Repeat Steps 2 to 5 to receive another station.
Ci you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
Tuning scale is:
FM: 50 kHz
AM: 10 kHz (to change to 9 kHz, see page 54.)