Audio Settings] - Sony BDV-E980 Manual

• [BD/DVD-ROM 1080/24p Output]
[Auto]: Outputs 1920 x 1080p/24 Hz video
signals only when connecting a 1080/24p-
compatible TV using the HDMI (OUT) jack.
[Off]: Select this when your TV is not
compatible with 1080/24p video signals.
• [YCbCr/RGB (HDMI)]
[Auto]: Automatically detects the type of
external device, and switches to the matching
color setting.
[YCbCr (4:2:2)]: Outputs YCbCr 4:2:2 video
signals.
[YCbCr (4:4:4)]: Outputs YCbCr 4:4:4 video
signals.
[RGB]: Select this when connecting to a device
with an HDCP-compliant DVI jack.
• [HDMI Deep Color Output]
_: Normally select this.
[16bit], [12bit], [10bit]: Outputs 16bit/l 2bit/
10bit video signals when the connected TV is
compatible with Deep Color.
[Off]: Select this when the picture is unstable or
colors appear unnatural.
• [Pause Mode] (BD/DVD VIDEO/DVD-R/
DVD-RW only)
[Auto]: The picture, including subjects that
move dynamically, is output with no jitter.
Normally select this position.
[Frame]: The picture, including subjects that do
not move dynamically, is output in high
resolution.
[Audio Settings]
• [BD Audio MIX Setting]
[On]: Outputs the audio obtained by mixing the
interactive audio and secondary audio to the
primary audio.
[Off[: Outputs the primary audio only.
• [Audio DRC]
You cau compress the dyuamic rauge of the
souud track.
[Auto]: Performs playback at the dynamic range
specified by the disc (BD-ROM only).
[Off]: No compression of dynamic range.
[On]: The system reproduces the sound track
with the kind of dynamic range that the
recording engineer intended.
• [Attenuate - AUDIO]
Distortion may occur when you listen to a
component connected to the AUDIO (AUDIO
IN L/R)jacks. You can prevent distortion by
reducing the input level on the unit.
[Ou]: Atteuuates the iuput level. The output
level is chauged.
[Off[: Normal iuput level.
• [Audio Output]
You cau select the output method where the
audio sigual is output.
[Speaker]: Outputs multi-channel sound t¥om
the system's speakers only.
[Speaker + HDMI]: Outputs multi-channel
sound from the system' s speakers and 2-channel
linear PCM signals trom the HDMI (OUT) jack.
[HDMI]: Outputs sound fiom the HDMI (OUT)
jack only. Sound tormat depends on the
connected component.
• When [Control lk)r HDMI] is set to [On] (page 61 ),
[Audio Output] is set to [Speaker + HDMI]
automatically and this setting cannot be changed.
• When [Audio Output] is set to [HDMI], the output
signal format for the "TV" and "SAT/CABLE"
function is 2-channel linear PCM.
m,
I£1
&
€,,,
3
¢D
=_.
59 us