Soleus Air KY-28U Owner's Manual page 6

2_
The water tank float lid should be
able to move up and down freely
after correct installment.
d_
Insert the complete water tank back
to the air conditioner unit.
Exhaust Duct
F_g. 1 c)
When you use the unit as an air conditioner, the hot exhaust air must be directed out of
the room. The exhaust duct is used to allow the hot air out. DO NOT 1NSTALL OR
USE THE EXHAUST DUCT WHEN THE U2qIT IS OPERATED AS A
DEHUMIDIFIER OR FAN.
a_
b_
Slid exhaust connector all the
over the discharge opening of
Mount the external end of the
duct onto a hole of 5 */4"(132
wall for optional wall hot air
installation, or
way down
the unit.
exhaust
mm) on the
outlet
c._
Connect the window kit adaptor to the external end of the
exhaust duct for a window or sliding door hot air outlet
installation.
NOTE: In order to increase the efficiency, the exhaust duct should
be keep as short and straight as possible. The exhaust hose can be
cut shorter by unthreading either end of the exhaust duct counter
clockwise. It is not recommended to increase the lnanuPacturer's
length of the exhaust hose. This may impede or damage the unit.
3) Window Kit Installation
a) Open window or sliding door for approximately 5 inches (130 mm)
b_
Adjust the length of the window kit to the same length of the window or the
sliding door. Use all three panels if necessary.
c) Use screws to affix the window kit length.
d_
Place the window kit to the window or sliding door. Close the window or door as
far as it goes.
-6-