Soleus Air KY-28U Owner's Manual page 15

shutsoff.
When the water tank is full, take out the entire water tank slowly and discard the water
inside the tank, place it back to its original position. You will then be able to turn on the
unit again.
If you want to take out the internal tank before it is full of water, please stop the unit first.
Wait for 3 minutes before taking out the water tank to prevent the condensate water from
discharging into the unit.
NOTE: Do not take out the water tank when the unit is running on either cooling or
dehumidifying mode or the alarm will sound and the compressor stops. The mode will
automatically change to FAN mode and the compressor will require approximately 3 minutes to
restart to the cooling/dehumidifying cycle.
2) Continuous Drainage
The unit can operate on continuous drainage mode. When the unit is operating on continuous
drainage mode, condensate water does not go to the internal water tank. Condensate is
discharged by gravity through the drainage tubing to either an external tank (not provided) or to a
condensate water pump device (Optional Item). When the unit is
operating on continuous drainage mode, it can operate
continuously without periodic stops to empty the water tank.
a) Pull out the plug of the drainage spout.
b)
Push/Click down the drainage spout and make it
direct downward.
Continuos
Plug
c)
Hold down the drainage spout, and then connect the
drainage tubing into drainage spout.
d)
Place the other end of the drainage tubing into
either an external water tank or the receptor of a condensate water pump.
D_ainagJe
Normal Operation
Mode