Dryer Use - Kenmore 110.C8756 Series Use & Care Manual

DRYER USE
STATUS AUTO
Power CYCLES Delicate _,_ DTIr_E R__%
Wet _ @ TIMED _E _
Damp_ J. Normal
Casual CYCLES O_ed Cycle
Cool Down Q Timed
Clothes Dry _ _ More Dry _A,_lust
Wrinkle Guard O _ Normal Jeans i
Controls Locked
_'_ Heaw Dul ...... Touch Up _
V
Check Lint Screen
Dryness
Level
AUto CYCLES ONLY _4fCEI_C
MODIFIERS & OPTIONS
High
Medium High
Medium
Low
_ _xtra Low
Air Only
0
Temperature
AD STSIM_ C_CES
O Wrinkle Guard 90
_ Cycle Signal
_OCK iUNOCK C ON _LS
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
De not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.
WARNING: To reduce the risk of fire, electric shock, or injury to To use an Auto Cycle
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
Follow these basic steps to start your dryer. Please refer to
specific sections of this manual for more detailed information.
f. Clean lint screen before each load. See "Cleaning the Lint
Screen."
2. Place laundry into dryer and shut door.
3. Press POWER.
4. Select an Auto or Timed Cycle. The preset settings for Auto
or Timed Cycles will illuminate. The estimated (auto cycle) or
actual (timed) cycle time (in minutes) will show in the display.
NOTE: A default time is displayed when an automatic cycle is
selected. During the first few minutes of the drying process,
the cycle time may automatically vary from the default time
based on the size and fabric type of the load. Toward the end
of the drying process, the estimated time display will adjust
again, showing the final drying time.
• Select an Auto Cycle. Auto cycles are preset to Normal.
• Select DRYNESS LEVEL to adjust how dry you want the
load. As the cycle runs, the control senses the dryness of
the load and adjusts the time automatically for the
selected dryness level.
To make changes to the Dryness Level and/or Options
during an Auto Cycle:
• Press STOP once.
14