Fence Components; Dust Collection - Grizzly EXTREME G0605X Owner's Manual

Fence Components

Components and Hardware Needed:
To install the fence knobs, fence, and fence
resting brackets:
1.
32
Figure 32
2.
3.
Adjusting Fence
4.
33
Figure 33
Qty
DO NOT operate the Model G0605X/G0606X
without an adequate dust collection system.
This saw creates substantial amounts of
wood dust while operating. Failure to use a
dust collection system can result in short
and long-term respiratory illness.
Figure
Components and Hardware Needed:
Recommended CFM at Dust Port:
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this cal-
culation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
To connect a dust collection hose:
1.
Page 54
2.
Figure
performance.
Figure 34.

Dust Collection

Figure 34
Note: A tight fit is necessary for proper
Qty
400 CFM