Grinding Wheels - Grizzly t10493 Owner's Manual

installing/changing

grinding Wheels

these angle grinders use type 27 grinding
wheels. refer to specifications on page
5 to match the grinder to the proper wheel.
see accessories on page 11 for wheel
options.
always install a grinding wheel that
is the correct size and rpm rating
for your grinder. failure to do so
may cause injury from the grinding
wheel failing and throwing pieces
toward the operator at high speed.
tools needed
Fixed pin spanner Wrench ...................... 1
new grinding Wheel ................................ 1
to install or change the wheel:
1. press the spindle lock button and rotate
the wheel until the button engages and
the spindle ceases to turn.
2. While holding the spindle lock button,
position the fixed pin spanner wrench in
the outer flange and turn counterclock-
wise to loosen the flange, as shown in
figure 18.
spindle lock
button
figure 18. Changing grinder wheel.
-16
-
Qty
hook
Wrench
3. remove the outer flange and old
wheel.
4. install the new wheel.
5. replace the outer flange and tighten
it while depressing the spindle lock
button.
note: The inner flange can unseat
once the wheel is removed. Be
sure the alignment keys of the inner
flange seat properly to the grinder
spindle and that the raised hub of
the outer flange seats inside the
bore of the grinding wheel, as shown
in Figure 19.
figure 19. inner and outer flange
installation alignment.
t10493, t10494 & t10495 (Mfg since 10/11)
grinder spindle
inner flange
Wheel
outer flange