Calibrating Depth Scale; Setting Fence Stops - Grizzly G0609X Manual Insert

Figure 56. Depth scale adjusted to "0" position.
G0609 12" Parallelogram Jointer

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Tools Needed
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 14mm ................................................... 1
To set the 45˚ inward fence stop:
1.
Tilt the fence approximately 45° inward
(Figure 57) onto the positive stop bolts using
a square.
Figure 57. Fence adjusted 45˚ inward.
2. Loosen the jam nut on the 45° inward positive
stop bolt shown in Figure 58.
3.
Adjust the positive stop bolts until the fence is
exactly 45° inward while resting on the bolts
(verify the angle with a 45° square).
4. Retighten the jam nut loosened in Step 2.
Qty
-41-