Grizzly G0609X Manual Insert page 57

To set the 90˚ fence stop:
1.
Lower the stop block against the fence, as
shown in Figure 59, and loosen the fence tilt
lock.
Figure 59. Adjusting fence to 90˚.
2. Tilt the fence to the 90° position.
3.
Using a 90° square, check the fence angle.
—If it is not set at exactly 90°, loosen the
jam nut and adjust the positive stop bolt
until the fence is exactly 90° as shown in
Figure 59.
4.
Tighten the jam nut.
-42-
To set the 45° outward fence stop:
1. Raise the stop block, loosen the fence tilt
lock, and position the fence against the 45°
outward positive stop bolt.
— If the fence is not set at exactly 45˚ out-
ward, loosen the jam nut on the 45˚ out-
ward fence positive stop bolt (Figure 60).
Figure 60. Adjusting fence 45˚ outward.
2. Adjust the 45˚ outward positive stop bolt until
the fence is exactly 45° outward while rest-
ing on the bolt (check the angle with a sliding
bevel set to 135°).
3. Retighten the jam nut loosened in Step 2.
G0609 12" Parallelogram Jointer