ppendix
• For replacement,
you willneed a 5.91Inches-long
Phillips screwdriver
and a pair ofgloves.
Unplug IV, then remove the 7
screws.
.... Remove
the rear cover.
Remove the 2 press-pin
screws the Lamp.
Separate the Lamp from the
engine by holding the handle
and pulling it out.
To reinstall the Lamp,
follow
these steps in reverse order.
NOTES
•
Be sure the replacement Lamp is the same lype.
•
After replacing the lamp, align the lamp cover with the groove and secure the screws.
•
The TV will not turn on if the lamp cover is not correctly closed (as this will activate the
protective circuit).
glish - 90