Operational Problems - Epson Aculaser M1200 series User Manual

2. Gently pull out any sheets that have fed part way into the printer.
3. Close the output tray, and open the printer's front cover.
4. Remove any pieces of paper that may have torn off or are remaining in the printer, and then
close the front cover.
Note:
If necessary, take out the developer cartridge and remove any paper left in the paper feed path.
Then reinsert the cartridge.
5. Tap the edges of the paper stack on a flat surface and carefully reload it into the MP tray.
Note:
Do not reload curled or wrinkled sheets.
6. Open the printer's front cover again, and then close it until it clicks shut. The jammed page's
print data is automatically reprinted.

Operational Problems

The Ready light does not turn on when you turn the printer on
Cause
The printer may not be connected to the electrical outlet.
The electrical outlet may be controlled by an outside
switch or an automatic timer.
EPSON AcuLaser M1200 Series
What to do
Turn off the printer and check the power cable
connections between the printer and the electrical
outlet; then turn the printer back on.
Make sure the switch is turned on or plug another
electrical device into the outlet to check whether the
outlet is operating properly.
User's Guide
Troubleshooting 103