How To; Overview - Epson SureColor F6070 Network Manual

How To

Overview

This section describes the general procedure on how to set up the network interface for
use on a network.
1. Check the network interface operation.
Check the functions and operations of the network interface, such as status lights and
RJ-45 connector. See "Network Interface Operation" on page 8 for details.
2. Select a printing method.
Select a printing method appropriate for your network environment and operating
system. If you are not sure, see "Printing from Windows" on page 12 for details.
3. Install the necessary components on your computer.
Make sure the necessary components (such as TCP/IP) are installed on the computer,
and network settings (such as IP address, subnet mask, etc.) of the computer is set.
See "About Installing Components on Your Computer" on page 13 for details.
4. Connect the network interface to the network.
Connect the network interface to the network. See "Connecting the Network Interface
to the Network" on page 16 for details.
5. Configure the network interface and install the printer driver.
See "Configuring the Network Interface" on page 17 or "Installing the Printer Driver" on
page 17 for details.
6. If necessary, configure the network settings of the network interface using EpsonNet
Config.
Configure the network interface for TCP/IP, AppleTalk, etc. using EpsonNet Config. For
Windows users, see "About EpsonNet Config" on page 26.
11
How To