Something Not Working - Electrolux EDC 77570 W User Manual

125987340.qxp 2007-03-16

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the
programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction
Dryer does not
work.
Drying results unsa-
tisfactory.
Loading door does
not close.
11:42 Page 21
Possible cause
•Mains plug is not plugged
in or fuse is not working
correctly.
•Loading door is open.
•Have you pressed the
START/ PAUSE button?
• Wrong programme
selected.
• Lint filter clogged.
• Heat exchanger clogged
with lint.
• Incorrect volume of laun-
dry.
• Ventilation slots in base
area covered up.
• Residue on inside surfa-
ce of drum or drum ribs.
• Conductance of water at
installation site differs from
standard setting of machi-
ne.
• Loading door does not
close.
something not work electrolux 21
Solution
• Plug in at mains socket
Check fuse in fuse box
(domestic installation).
• Close loading door.
• Press the START/PAUSE
button again.
• Select a different programme
the next time you dry
• Clean lint filter.
• Clean heat exchanger.
• Observe recommended loa-
ding volumes.
• Uncover ventilation slots in
base area.
• Clean inside surface of drum
and drum ribs
• Re-programme standard sett-
ting for degree of drying (see
Programming options' section.
• Install fine strainer and/or
snap large mesh filter into
place.
G G B B