Table of Contents
Advertisement
First Time Setup —Continued
Speaker Setup
Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 37).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Speaker Configuration
This setting is set automatically by the Automatic
Speaker Setup function (see page 37).
Here you can specify which speakers are connected and
their individual sizes.
For speakers with a cone diameter
over 6-1/2 inches (16 cm), specify
large, and for those with a diameter
below this, specify small.
1
2, 3
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
42
2
ENTER
ENTER
3
ENTER
ENTER
Cone diameter
4
ENTER
2–11
1, 12
5
ENTER
Use the Up and Down [
]/[
buttons to select "2. Speaker
Setup," and then press [ENTER].
The Speaker Setup menu appears.
Use the Up and Down [
]/[
buttons to select "1. Speaker
Config," and then press [ENTER].
The Speaker Config menu appears.
Menu
------------------------
Basic Setup
2.Speaker Setup
1.Initial Setup
------------------------
2.Speaker Setup
1.Speaker Config
2-1.Speaker Config
2.Speaker Distance
------------------------
Advanced Setup
3.Level Calibration
a.Subwoofer
:Yes
3.Surround Setup
4.Equalizer Settings
b.Front
:Large
4.Audio Adjust
c.Center
:Small
5.Listening Mode Preset
d.Surround
:Small
6.Preference
e.SurroundBack :Small
f.SurrBack ch
:2ch
g.Crossover
:100Hz
h.Double Bass
:Off
Use the Up and Down [
]/[
buttons to select "a. Subwoofer,"
and then use the Left and Right
[
]/[
] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
Use the Up and Down [
]/[
buttons to select "b. Front," and
then use the Left and Right [
[
] buttons to select:
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 4 is
set to No, this setting is fixed at
Large.
]
]
]
]
]/
Advertisement
Table of Contents
