Table of Contents
Advertisement
Advanced Setup
Decoder Setup
Here are surround-related settings for PCM, Dolby Dig-
ital, multichannel, and other input signal formats.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "3. Decoder
Setup," and then press [ENTER].
ENTER
The Surround Setup menu appears.
Menu
------------------------
Basic Setup
3.Decorder Setup
ENTER
------------------------
1.Initial Setup
2.Speaker Setup
Advanced Setup
3.Surround Setup
4.Audio Adjust
5.Listening Mode Preset
6.Preference
3
Use the Up and Down [
buttons to select the menu items,
and then press [ENTER].
ENTER
ENTER
4
Use the Up and Down [
buttons to select the settings,
and use the Left and Right [
ENTER
[
] buttons to set them.
The settings are explained below.
5
When you've finished, press the
[SETUP] button.
The setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
62
]/[
]
1.Analog/PCM
2.Dolby Digital
3.DTS
4.D.F.2ch
5.Multiplex
6.Multich Input
]/[
]
]/[
]
]/
• The Surround Mode and SurrBack Mode settings can
also be changed by using the remote controller's
[SURR] button.
3-1. Analog/PCM
These settings apply to PCM input signals from CD
players and so on, and analog signals from cassette play-
ers, turntables, and so on.
■ a. Input Channel (Mono)
This setting determines which channel is output when
the Mono listening mode is used with a stereo source.
L+R: Both the left and right channels are output
(default).
Left: Only the left channel is output.
Right: Only the right channel is output.
■ b. Surround Mode
This setting determines the surround mode for analog
and PCM input signals. This setting is unavailable if no
center and surround speakers are connected.
You can select PLIIx Movie (default), PLIIx Music,
PLIIx Game, Neo:6 Cinema, or Neo:6 Music.
If you're not using any surround back speakers, "PLIIx"
will be "PLII."
If you're not using any surround speakers, Neo:6 Music
cannot be selected.
3-2. Dolby Digital
These settings apply to Dolby Digital input signals.
■ a. LFE Level
With this setting, you can set the level of the LFE (Low
Frequency Effects) channel for Dolby Digital sources to
∞
–
, –10 dB, or 0 dB (default).
If you find that the low-frequency effects are too loud
when playing Dolby Digital sources, set this to –10 dB
∞
or –
dB.
■ b. Dolby EX
This setting determines how Dolby Digital EX signals
are handled. This setting is unavailable if no surround
back speakers are connected.
Auto: If the source signal contains a Dolby Digital
EX flag, the Dolby Digital EX listening mode
is used.
Manual: Depends on the c. SurrBack Mode setting.
Advertisement
Table of Contents
