Whirlpool LGT7646AQ0 Use And Care Manual page 8

Using the automatic cycles
Your DRY-MISEFP control senses the dryness
of the load and automatically shuts off when the
selected dryness is reached, For the first few
loads:
1. Set the Cycle Control Knob to point to the
center mark in your automaticcycle.
2. Select a heat setting to matchyour load,
3. Push the Start Button,The Cycle Control
Knob will not move until the load is almost
dry or the cool-down portion of the cycle
has been reached. After the cool down is
complete, the Cycle Control Knob automati-
cally moves to an OFF area and the
tumblingstops.
Cycle control knob
with temperatures
built-in
Models with a tempera-
ture selector
Feel the dried items when the dryer stops.
ff the item,=are drier than you like, select a
setting closer to LESS DRY the next time you
dry s similar load.
If Items are not as dry as you like, select a
setting closer to VERY DRY the next time you
dry a similar load.
Cycle control knob
with temperatures
built-in
Models with a tempera-
ture selector
Automatic DRY-MISER control
(on somemodels)
The automatic DRY-MISER control uses a
thermostat that senses the dryer's air tempera-
ture. The dryer automaticallyshuts off when
the selected dryness is reached.
Electronic DRY-MISER control
(on ,,omomodal=)
The electronic DRY-MISER controluses an
electronicsensor that determines the amount
of moisture in the clothes.The dryer automati-
cally shuts off when the selected dryness is
reached.