Whirlpool LE5200XT Use & Care Manual page 13

Drum seal
VlewB
right
RqHnOVO R
before opening lop
VlewA
Side panel
wire clips
Front pimei
wire clip
(,._ vim c)
Belt
Wire dip-
holds door
switch wires
VIewC
VlewD
If your dryer I1 gas Ind hu I lull front
pilel, remove irontpill mi Ionom:
1. Unplug the power supply cord or turn
off the electrical power.
2. Open lint screen lid. Remove two
screws in lint screen area.
3. Open top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top is hinged st rear).
4. Remove two internal screws from
front panel flanges (near top front
comers). Liftfront panel slightly,
liftingoff lower clips (see view B).
Slowly pull front panel forward,
disengaging panel from drum.
(Drum will drop slightly.)
& Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire clips (see view (3) or
damaging wires.
6. Remove tint from area shown in "gas
dryer" illustration on page 12 with soft
brush or vacuum cleaner. Avoid
damaging wires, funnel or igniter.
7. Reassemble in reverse order. Before
closing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positioned
against panel at back of drum.
Rotate drum counterclockwise one
full turn to check drum seal.
- Belt should be centered and tight
on dryer drum.
- Wire clips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along lop edge of side
panel. Door wires must not touch
drum when dryer is operating.
See Warning, page 12.
8. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconnect power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
1-800-253-1301 for assistance or
more information.
13