Maintenance - Craftsman 911633 Owner's Manual

Consequently, it
IS
not
recommended that this
1001
be
used for extended work on any
fiberglass matenal, wallboard,
spackling compounds or plaster
During any use on Ihese
materials it is exllemely
important that the
1001
is cleaned
frequently by blowing out with an
airjel.
MAINTENANCE
CLEANING
DO NOT use solvents when
cleaning plastic parts. Most
plastics are susceptible to
damage from various types of
commercial solvents and may be
damaged by their use. Use clean
cloth to remove dirt, dust, oil,
grease, etc.
III
WARNING
I
Do not at any time allow brake
nuids, gasoline, petroleum-
based products, penetrating
oils,
etc.
to come in contact
with plastic parts. They
contain chemicals that can
damage, weaken or destroy
plastic.
It has been found that electric
tools are subjected to
accelerated wear and possible
premature failure when they are
used on fiberglass
boats
and
sports cars, wallboard, spackling
compounds or plaster. The
chips
and grindings from these
materials are highly abrasive to
electric tool parts such as
bearings, bnushes, commutators,
etc.
III
WARNING
I
Always wear safety goggles
or
safety glasses with side
shields during all sanding
operations. It is critical that
you also wear safety goggles
or safety glasses with side
shields and a dust mask while
blOwing dust out of the sander
I
with an air jet. Failure to take
these safety precautions could
result in permanent eye or
lung damage.
LUBRICATION
All of the bearings in this sander
are lubricated with a sufficient
amount of high grade lubricant
for the life of the unit under
normal conditions. Therefore, no
further lubrication is required.
16