Troy-Bilt 01919-1 Owner's Manual page 12

SPEC FmCATmONS
Starting VVatts ......................... 8,550 watts
Wattage ............................. 5,550 watts
AC Load Current:
At H20VoHts ......................... 46.2 Amps
At 240VoHts ......................... 23.H Amps
Phase .................................. H-phase
Rated Frequency ......................... 60 Hertz
FueHTank Capacity .................... 5 U.S. gaHHons
Shipping _A/oght .......................... H69 Hbs.
GENERAL MAINTENANCE
RECOMMENDATmONS
The Owner/Operator is responsible for making sure that
aHH periodic maintenance tasks are completed on a timeHy
basis; that aHH discrepancies are corrected; and that the unit
is kept dean and properHy stored. NEVER operate a
damaged or defective generator.
ShouHd you have questions about repHadng components on
yourTroyoBHtO generator, pHeasecaHH 1-888-611-6708 for
assistance.
Engine Maintenance
See engine owner's manuaHfor instructions.
CAUTION
m
. Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
. Thoroughly wash exposed areas with soap and waten
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OILTO COLLECTION CENTERS.
Generator Maintenance
Generator maintenance consists
of keeping the unit dean
and dry. Operate and store the unit in a dean dry
environment where it wiHHnot be exposed to excessive
dust, dirt, moisture or any corrosive vapors. CooHing air
shots in the generator must not become dogged with snow,
Heaves or any other foreign materiaH.
NOT[:: DO NOT use a garden hose to dean generator.
Water can enter engine fuel system and cause probHems. [n
addition, if water enters generator through cooHing air shots,
some of the water wiHH be retained in voids and cracks of
the rotor and stator winding insuHation.VVater and dirt
buiHdup on the generator internaH windings wiHH eventuaHHy
decrease the insuHation resistance of these windings.
Generator Cleaning
o Use a damp cHoth to wipe exterior surfaces dean.
®
®
®
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors_
DO NOT insert any objects through cooling slots.
Use a soft bristle brush to Hoosen caked on dirt or oiH.
Use a vacuum cHeaner to pick up Hoose dirt and debris.
Use How pressure air (not to exceed 25 psi) to bHow away
dirt. Inspect coding air shots and opening on generator.
These openings must be kept dean and unobstructed.
D ata Tag
Data tag information is very important
if you need heHp from
our Customer Service Department or an authorized service
dealer.
o The data tag (Figure 9) is located either on the heat shieHd
or engine support on the muffler side of the generator.
For future reference, pHease copy the model revision, and
seriaH number of the generator in the space below.
MODEL
REV NO
SERIAL
"1 Copy Revision
_ Here
_ Copy SeriaH
Number Here