Troy-Bilt 01919-1 Owner's Manual page 10

Section 4: Opecat[on
I
CAUTION
m
. NEVER attempt to power a device requiring more amperage
than generator or receptacle can supply.
. DO NOT overload the generator: See "Don't Overload
_enerator",
120/240 Volt AC, 30 Amp, Locking
Use a NEP1A LH4-30
piug with this receptacie. Connect a
4-wire cord set rated for 250VoHtAC ioads at 30 Amps (or
greater) (Figure 5).You can use the same 4-wire cord if you
_ian to run a i20Voit ioad.
4oWire Cord Set
/
/ \
(Neutral)
L0_0 _ ° _ Y(Hot) X(Hot)
NEbIA L I4-30 /_7
Ground (Green)
This receptacle powers i20/240VoitAC, 60 Hz, single
phase loads requiring up to 5_550 watts of power
(5.55 kW) at 23.1 Amps for [20Volts or 240Volts.The
oudet is protected
by a push-to-reset
circuit breaker.
120 Volt AC, 20 Amp,
Duplex
Use each receptacle to operate 120VoltAC, single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20 Amps of current. Use cord sets that are rated for
125 Volt AC loads at 20 Amps (or greater).
G E N E RATO R ADAPTE R
CORD SET
The generator is equipped with a 25' generator adapter cord
set designed for a 240Volt, 30Amp grounded neutral circuit
(Figure 7).The generator adapter cord set provides a
convenient supply of emergency power into your dwelling so
that your generator can be operated safely outside.
Each duplex receptacle (Figure 6) is protected against
overload by a push-to-reset circuit breaker.
The maximum load on each oudet is 20 Amps.The
maximum total load on both yellow wire oudets or black
wire outHets is 30 Amps.
NOTE: Follow ail safety precautions when connecting any
extension cord or device to the generator.