Sharp BD-HP20U Operation Manual page 40

SETTINGS
5 Press A/V/_/_ to select the speaker, then
7
Repeat steps 5 and 6 until each speaker's size,
press ENTER. and level are set.
6
Press 4/_ to select the preferred item, then
press A/V to select the preferred setting, then
press ENTER.
NOTE
" The speakers L and R, LS and RS move relative to one another.
,, The speakers L and R are automatically set to "LARGE" when the
subwoofer SW is set to "NO", even after speakers L and/or R are
set to "SMALL".
,, The images of speakers set to "NONE" disappear or are greyed
out on the screen.
,, As for a subwoofer, there are no settings for distance only for level.
8 Press A/T/4/_ to select "TEST START", then
press ENTER.
L/R LARGE*, SMALL
C/RS/LS LARGE*, SMALL, NONE
SW YES*, NO
* Factory preset
LARGE: The cone diameter is 6.3 inches or larger.
SMALL: The cone diameter is smaller than 6.3 inches.
lft through 29ft
(Settings available in lft increments)
The factory preset value: 12ft(L/R/C)
6ft(RS/LS)
6dB through +6dB
(Settings available in ldB increments)
The factory preset value is 0dB.
• After switching to TEST mode, you can hear the Test
sound from each speaker in turn.
If you press A/T/_II/_ to select the preferred
speaker while the TEST sound is present, you
can hear the TEST sound of the speaker that you
selected.
If you press _,/Y/_II/_ to select "TEST TONE
STOP" and press ENTER, you can stop the Test
sound
(_) =38