Sharp BD-HP20U Operation Manual page 37

SETTINGS
_ This sets the audio output mode for DIGITAL AUDIO OUT (COAXIAL jack / OPTICAL terminal) when selecting
OPTICAL/COAXIAL DIGITAL OUTPUT or 2ch AUDIO OUTPUT
DOLBY DIGITAL
DTS
AAC
BITSTREAM
PCM (STERE())
" Select this when connecting to SURROUND
equipment with a built in decoder for DOLBY DIGITAL,
DTS, AAC.
,, Setting to BITSTREAM will output each audio signal
by BITSTREAM.
,, Select this when connecting to 2 channel stereo audio
equipment.
,, Setting to PCM (STEREO) will output by converting
each audio signal into PCM 2channel audio signal.
DYNAMIC RANGE CONTROL
,, This lets you adjust the range between the loudest and softest sounds (dynamic range) for playback at average volume.
Use this when it is hard to hear dialogue.
NORMAL*: The some
audio output range is
played as the original
recorded audio output
range.
SHIFT: When Dolby
Digital audio is played
back, the dynamic
range of the audio is
adjusted so that the
dialogue portion can be
heard easily. (If the audio
sounds abnormal, set to
"NORMAL".)
Lower the audio volume before setting. If you do not do so, the speakers may emit a loud sound or excessive output
may be applied to the speakers.
DOLBY
DIGITAL
DTS
AAC
BITSTREAM
PCM
(STEREO)
SHIFT,
NORMAL
O_
m=
(_ - 35