Sharp BD-HP20U Operation Manual page 31

Playback Functions
AUDIO SUBTITLE
REPEAT-- OFF
FWD
iiiiiii!ii!!iiiiil
SKIP SKIP
8
%!C!i_ i_C;IID CIIICi C CII_
1 Press REPEAT during playback.
2
Press 4/_ to select "SCENE
SELECTION", then press ENTER.
[ i
_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
3
4
"SET START POINT" displays, press
ENTER at the scene where you
want.
• "SETEND POINT"displays.
Press ENTER at the scene where
you want to set the end point.
You can press _- FWD to fast
forward to the scene where you want
to set the end point. When you reach
the desired scene, simply press _.
PLAY and then ENTER to set the end
point. To cancel Repeat Playback,
press REPEAT-OFF.
NOTE
" Press |_m_| SKIP, the Repeat Playback is
cancelled and the next chapter being played back.
,, Press ll4.,_ SKIP once, the Repeat Playback
is cancelled and the player returns to the start of
current chapter (track).
,, If you press |4"_ SKIP again (within about 5
seconds) the player will skip to the beginning of the
previous chapter (track).
,, For Partial Repeat Playback, set the start and end
points within the same title.
,, Repeat Playback may be forbidden depending on
the disc.
,, Partial Repeat Playback may not work in multi
angle scenes.
,, If you press DISPLAY, you can confirm the Repeat
Playback status.
You can change the audio output channel using
AUDIO.
Each time AUDIO is pressed, the audio
channels change as follows:
The audio track currently being played back will
be displayed.
VR MODE
When a recorded broadcast with a
Secondary Audio Program is played back:
Switches between "L", "R" and "L+R".
When a recorded broadcast with stereo or
monaural audio is played back:
"Stereo" is displayed. (Audio cannot be
switched.)
NOTE
,, When you play a program recorded in stereo
or monaural, and if you are listening to the
BITSTREAM sound via the digital output jack, you
cannot select the audio channel. Set "AUDIO OUT"
to "PCM" (page 35), or if you want to change the
audio channel, listen via the analog output jacks.
If subtitles are provided in multiple languages,
you can switch between them.
Press SUBTITLE
during playback.
,, The display indicates the subtitle number currently
being played back, and the subtitles appear.
Each time SUBTITLE is pressed, the subtitles
change.
,, .... is displayed if a disc has no subtitles.
,, You can also select "OFF".
Q - 29