Connecting Cable Tv - Samsung Series6 650 PN50A650 User Manual

Connecting Cable TV
To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
1 Plug the incoming cable into the ANT IN terminat on the back of the TV.
Because this TV is cable-ready, you do not need a cabte box to view
unscrambled cabte channels.
Connectin$Lto a Cable Box that Descrambles All Channels
1 Find the cable that is connected to the ANT OUT termina! on your cabte box.
This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".
2 Connect the other end of this cabte to the ANT IN terminal on the back of the TV.
i ................................................
Connectin$!_to a Cable Box that Descrambles Some Channels
if your cable box descrambles only some channels (such as premium channels), follow the instructions below.
You will need a two-way splitter, an RF (A/B) switch, and four lengths of Antenna cable. (These items are available
at most electronics stores.)
1 Find and disconnect the cable that is
connected to the ANT IN termina! on your
cabte box.
This terminal might be labeled "ANT
IN", "VHF IN" or simpiy, "IN".
2 Connect this cabte to a two-way splitter.
Connect an Antenna cable between an
OUTPUT terminal on the sptitter and the IN
terminal on the cabte box.
Connect an Antenna cable between the
ANT OUT terminal on the cable box and the
B-IN terminat on the RF(A/B) switch.
Connect another cable between the other
OUT terminal on the sptitter and the A-IN
terminal on the RF (A/B) switch.
Connect the tast Antenna cable between
the OUT terminal on the RF (A/B) switch
and the ANT IN terminat on the rear of the
TV.
Incoming
cable
Splitter
Incoming
cable
Splitter
_ncoming I,_ c,,[_Li OL,,
cable _ _
Splitter RF (A/B}
Cable BOX Switch
Splitter
RF(A/B!
Cable Box Switch
__ tv
.... rt,n_ _ _ F _-_ _ .....
cable Splitter _ _ RF (A/B)
Switch
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B"
position to view scrambled channels. (When you set the A/B switch to "B", you witt need to tune your TV to the cane box's
output channel, which is usually channet 3 or 4.)
I BN68 01532A Engindb 10 2008 04 18 2_ 8:36151