How To Find The Tv's Video Input Channel - RCA VR354 User Manual

HOWTO FIND THE TV'S
VIDEO INPUT CHANNEL
You need to tune your TV to the Video Input Channel if you are
using the VCR's VIDEO/STEREO OUT jacks to connect to the TV's
VIDEO/STEREO INPUT jacks. You must select this "channel"
before you can see the VCR's menus, the cable or antenna
reception, and the content that's on a tape.
The video channel on TVs varies for different brands and
different models. Below are some steps to try:
• If your TV brand is RCA, GE, or PROSCAN, press the TV button
on the remote control that came with the VCR. Then press
the INPUT button on the remote.
• If you have another brand of TV, consult the section, VCR
BASICS, to see if the VCR's remote control can be set to
control your TV. If so, follow the step above.
If those options do not work, try the following ideas. You might
access the Video Input Channel by:
• pressing a button on the remote (see table below)
• selecting the channel from the TV's menu system
(see table below)
• tuning directly to the channel by selecting a specific channel
number (see table below)
• going through all the channels in the channel list by pressing
the channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input Channel
Variations table that follows:
INPUT
Button
_N_FF TV VCR
0o©
REVERSE P_Y FO_AR[
RECORD STOP PAUSE
INFO OHAN
MUTE CHAN GOBACK
@©@
CLEAR MENU SPEED
0
,0
54
Video Input Channel Variations
Button/Switch Button on the Channel
on the TV TV Remote Number
VIDEO VlD 1 00
SIGNAL LINE 90
VlD 1 VlD 91
VtD 2 VIDEO 92
S-VlD S-VlD 93
S-VIDEO INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX