Table of Contents
Advertisement
STEP 1: UNPACK
TH E TV
Make sure to locate the remote control.
STEP 2: CONNECTING
YOUR TV
There are three types of connections
outlined in this section:
TV Only:
The Basic Connection:
If you're only going to connect the
TV to your home antenna or cable
system.
If you're going to connect the TV to a
VCR or satellite receiver.
Advanced
Connections:
If you're going to make multiple
connections, hooking up the TV to
one or two VCRs, DVD player, and a
satellite receiver.
Cable information
and illustrations are given for each type of connection.
Once you have completed your desired connection you may skip forward
to Step 3.
Before You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the wall
outlet.
• Turn off the TV and/or component
before connecting or disconnecting any
cables.
• Make sure all antennas and cables are
properly grounded. Refer to your
Safety Tips sheet packed with your TV.
TV ONLY
This is a basic connection from an antenna or cabie system to your "IV.
Connect the cable into the Cable/Antenna
jack as shown.
Cables
You will use the following cable to make your connection:
Coaxial
Cable: These cables carry audio and video
signal to the TV from an antenna, cable, or
cablebox.
CABLE, CABLE BOX, OR ANTENNA
Once you have completed this connection you may skip to Step 3.
4
Advertisement
Table of Contents
