Table of Contents
Advertisement
Setup and Connections
Step 1: Unpack the TV
Make sure to locate the remote control.
Step 2: Connecting your TV
There are three types of connections outlined in this section:
TV Only:
The Basic Connection:
Advanced Connections:
Cable information and illustrations are given for each type of connection.
Once you have completed your desired connection you may skip forward
to Step 3.
TV Only
This is a basic connection from an antenna or cable system to your TV.
Connect the cable into the Cable/Antenna jack as shown.
Cables
You will use the following cable to make your connection:
Coaxial Cable : These cables carry audio and video
signal to the TV from an antenna, cable, or
cablebox.
Once you have completed this connection you may skip to Step 3.
4
If you're only going to connect the
TV to your home antenna or cable
system.
If you're going to connect the TV to a
VCR or satellite receiver.
If you're going to make multiple
connections, hooking up the TV to
one or two VCRs, DVD player, and a
satellite receiver.
Before You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the wall
outlet.
• Turn off the TV and/or component
before connecting or disconnecting any
cables.
• Make sure all antennas and cables are
properly grounded. Refer to your
Safety Tips sheet packed with your TV.
Advertisement
Table of Contents
