Setup And Connections; Step 1 : Unpack The Tv; Step 2: Connecting Your Tv; Only - RCA PS27600 User Manual

SETUP AND CONNECTIONS
STEP I:
UNPACK THETV
Make sure to locate the remote control and your GUIDE Plus+ Booklet.
STEP 2:
CONNECTING YOUR'FV
There are three types of connections outlined in this section:
IV Only: If you're only going to connect the
TV to your home antenna or cable
system.
The Basic Connection: If you're going to connect the TV to a
VCR or satellite receiver.
Advanced Connections:
If you're going to make multiple
connections, hooking up the TV to
one or two VCRs, DVD player, and a
satellite receiver.
Cable information and illustrations are given for each type of
connection. Once you have completed your desired connection you
may skip forward to Step 3.
ONLY
This is a basic connection from an antenna or cable system to your TV.
Connect the cable into the Cable/Antenna jack as shown.
CABLES
You will use the following cable to make your connection:
Coaxial Cable: These cables carry audio and video
signal to the TV from an antenna, cable, or
cablebox.
Important Stand Information
Direct View
TVs: 13"
- 36" diagonal
CAUTION: Choose the location for your
TV carefully. Take precautions that the
stand or other furniture the TV is placed
on is properly located (see Important
Safeguards sheet) and of adequate size
and strength to prevent the TV from
accidentally being tipped over, pushed
off, or pulled off. This could cause
damage to the TV and/or personal injury.
m
Before You Connect
Protect against power surges:
• Connect all components before |
plugging any power cords into the wall [
outlet. /
• "Turn off the TV and/or component |
before connecting or disconnecting [
any cables. /
• Make sure all antennas and cables are |
properly grounded. Refer to your Safety |
__ Tips sheet packed with your TV. )
CABLE, CABLE BOX, OR ANTENNA
Once you have completed this connection you may skip to Step 3.
4