Table of Contents
Advertisement
SETUP AND CONNECTIONS
STEP I:
UNPACK
THETV
Make sure to locate the remote control and your GUIDE Plus+ Booklet.
STEP 2:
CONNECTING
YouRTV
There are three types of connections
outlined
in this section:
TV Only:
If you're only going to connect
the
TV to your home antenna or cable
system.
The Basic Connection:
If you're going to connect the TV to a
VCR or satellite receiver.
Advanced Connections:
If you're going to rnake multiple
connections, hooking up the TV to
one or two VCRs, DVD player, and a
satellite receiver.
Cable information and illustrations are given for each type of
connection. Once you have completed your desired connection you
may skip forward to Step 3.
TV ONLY (PIP NOT
AVAILABLE)
This is a basic connection from an antenna or cable systern to your TV.
Connect the cable into the Cable/Antenna jack as shown.
CABLES
You will use the following cable to make your connection:
Coaxial Cable: These cables carry audio and video
signal to the TV from an antenna, cable, or
cablebox.
CABLE, CABLE BOX, OR ANTENNA
Once you have completed
this connection
you may skip to Step 3.
r _
Important
Stand Information
Direct View TVs: 13" - 36" diagonal
CAUTION: Choose the location for your
TV carefully. Take precautions that the
stand or other furniture the TV is placed
on is properly located (see Important
Safeguards sheet) and of adequate size
and strength to prevent the TV from
accidentally being tipped over, pushed
off, or pulled off. This could cause
damage to the TV andk)r personal injury.
Before You Connect
Protect against power surges:
• Connect all components before
plugging any power cords into the wall
outlet.
• Turn off the TV and/or component
before connecting or disconnecting
any cables.
• Make sure all antennas and cables are
properly grounded. Refer to your Safety
Tips sheet packed with your TV.
r _
This Connection
Will Not Allow
You to Use Your PIP
Your TV is equipped with a single tuner
which means you rnust connect with a
second video source using Audio/Video
Cables. This TV Only connection will
not enable you to use your PIP, but will
get your TV up and running quickly.
Refer to Advanced Connections for
connecting Audio/Video cables to your
VCR or other vide{) component.
-Your TV May Differ
1
|Model
PS27500 does not have an
IS-Video
jack for INPUT2 nor external
kspeaker
terminals.
4
Advertisement
Table of Contents
