Table of Contents
Advertisement
Your TV includes a feature called
SRS (O)* (Sound Retrieval
System)
which brings dimensional
realism to
both stereo and mono broadcasts.
When the SRS ON/OFF
function
is
set to ON and the STEREO/SAP
function
is set to STEREO,
your TV
electronically
increases
the audio
separation
of the speakers so you can
perceive
a more spacious
stereo
sound effect.
If a stereo signal is not
present,
you can set the SRS
ON/OFF
function to its SYNTH
STEREO
setting to synthesize
and
process the mono signal.
When the SRS ON/OFF
function
is
set to ON, you can also change the
next menu item called SRS WIDTH
between NORMAL
or ENHANCED.
When this function is set to
ENHANCED,
the perceived
audio
separation
will be greater.
Try both
settings and select the one you prefer
for your room acoustics.
Note: Some material (audio) will be more
affected than others.
SRS (O) allows you to hear multiple
sound sources. Audio frequencies
are
processed
to establish
directional
cues which gives the impression
that
sound is coming from all parts of the
room. External
speakers
are not
required,
but the addition of high
quality external speakers
optimizes
the sound performance
of your TV.
*SRS and (O) are registered trademarks of Hughes
Aircraft Company, a division of GM Hughes Electronics.
-Turning
On SRS (O)
1. Repeatedly
press the MENU button
to
select AUDIO
MENU, press +, and
then repeatedly
press MENU
again to
select SRS ON/OFF
function.
Note: You can also change the
SRS:ON/OFF function between ON and
OFF without going through the menu by
pressing the SRS button on the remote.
2. Repeatedly press the + button to
change the settingbetween
OFFI
ON,
and SYNTH
STEREO.
• If the broadcast you are receiving is
stereo audio, select ON. The
STEREO/SAP function must be set
to STEREO before you can hear
SRS (0) sound with this setting.
• If the broadcast you are receiving is
mono audio, select SYNTH
STEREO.
• If you do not want SRS (O), select
OFF.
3. Press MENU button to select next
menu item called SRS WIDTH.
Pressing + or - will change the
setting between NORMAL and
ENHANCED.
Try both settings and
select the one you prefer.
Note: After turning SRS or synthetic
stereo on, you may find it desirable to
readjust the VOLUME, BASS, and
TREBLE controls to optimize the sound.
The SRS effect, tonal balance, and
volume level will vary from channel to
channel depending on the production
qualities of the program material.
11
Advertisement
Table of Contents
