Table of Contents
Advertisement
Using Direct Entry
1.
Turn on the component to be programmed.
2.
Look up the brand and code number(s) for the component on the
code list in the section "Remote Control Codes" on the following
page.
3.
Press and hold the remote control button you want to program.
4.
Enter the code from the code list.
5.
Release the button, and then press ONoOFF to see if the component
responds to the remote control commands. If it doesn't, try pressing
the component button and then ONoOFF again.
6.
If you get no response, repeat these steps using the next code listed
for your brand until the component responds to the remote control
commands.
This remote control may not operate all
models of the brands that are shown.
Use
the codes shown in this manual, or on the
sheet packed with your remote control.
Use the AUX button to control a separate
satellite
receiver, if necessary. Do not
reprogram the DIRECTV button.
USI NG THE REMOTE
TO CONTROL
A
COMPONENT
Once the remote has been programmed
successfully, you are ready to
use it to control your components,
such as a VCR, DVD player, or
laserdisc player.
To operate
the component:
1.
Press the component
button
(VCR1, VCR2, DVD, or AUX) to set the
remote to control the component.
2.
Press ONoOFF to turn the component
on or off.
3.
Use the remote control
buttons that apply to that component.
21
Advertisement
Table of Contents
