Table of Contents
Advertisement
AUTO
TUNING
This menu displays the various components
you have connected
to your
TV. It lets you set up the TV to automatically
tune to the correct input
channel when you press a device button
(VCR1, VCR2, or DVD) on the
remote control.
1.
Use the arrow buttons
on the remote control
to highlight
the field
corresponding
with a device.
Selecting any of the fields on this screen enables you to
specify which input
or channel
the component
will use.
2.
Press the OK button
on the remote to choose which input channel
you want to tune to when you press that device button.
Choices for
each device are:
3.
Not Connected
Select this if you don't
have that device
connected
to the antenna or video input jack on the back of the TV
or if you don't want the TV to tune to a channel when the particular
device button
(VCR1, VCR2, or DVD) is pressed.
Ch 2 (or 3 or 4) - Ant A
Select this if your device is connected
to
Antenna
A on the back of the TV and you want the TV to tune to
channel 2 (or 3 or 4) when you press the device button
(VCR1, VCR2,
or DVD).
Ch 2 (or 3 or 4) - Ant B Select this if your device uses Antenna
B
on the back of the TV and you want the TV to tune to channel 2 (or
3 or 4) when you press the device button
(VCR1, VCR2, or DVD).
Video INPUT 1 (or 2 or 3)
Select this if your device is connected
to the Video INPUT 1 (or 2 or 3) jack on the back of the TV and you
want the TV to tune to the input channel VID1 (or VID2 or VID3)
when you press the button.
If you have an S-Video cable connected,
the input channel will read S-VID1 (or S-VID2 or S-VID3).
Cmpnt
Video (Component
Video Input)
Select this if your
device is connected to the COMPONENT VIDEO INPUT jack on the
back of the TV and you want the TV to tune to the input channel
CMPNT when you press the device button
(VCR1, VCR2, or DVD).
Now you can use the device buttons
(VCR1, VCR2, or DVD) on the
remote control to tune to the correct input channel when you press
the button.
If you have programmed
your remote control
and completed
the above
steps to auto tune, you can--for
example--press
the VCR button
and
both tune to the VCR's input channel and enter into "VCR mode." You
can then begin using the REVERSE, PLAY, FORWARD, RECORD, STOP, and
PAUSE buttons to control your VCR.
I Reminder: Make sure the Ch 2/3/4 switch
|
on the back of the component is set to the
J
channel you specify in the Auto Tuning
screen.
65
Advertisement
Table of Contents
