Table of Contents
Advertisement
Using the Remote
Control
Using Direct Entry
1.
Turn
on the component
you want the remote
to operate.
9.
Look up the brand and
code
number(s)
for the component
on the code
list on page
26.
3.
Press and hold the component
button
that corresponds
to the component
you want the
remote
to operate
(VCR1,
DVD, etc.)
4.
Enter
the code
from
the code
list.
5.
Release
the component
button.
6.
Press ON*OFF
to see if the component
responds
to the remote
commands.
If it doesn't,
try
pressing
the component
button
and then ON*OFF
again.
7.
If you get no response,
repeat
these
steps using
the next code listed for your brand until the
component
responds
to the remote
commands.
/ip
The buttons might
operate differently
for
other components,
especially
when you're
using another
eomponent's
menu
system,
How to Use the Remote After You've
Programmed
It
Once the remote has been programmed
successfully, you are ready to use it to control your
components.
To operate
the component:
1.
Press the component
button
(TV, VCR1, VCR2, DVD, AUX, or SAT*CABLE) to set the
remote to operate
the component.
2.
Press ONoOFF to turn the component
ON or OFE
3.
Use the remote buttons
that apply to that component.
Note: If you keep pressing buttons and nothing happens, the remote is probably in the wrong mode.
You must press the component button that matches the component you want to operate (i.e., if you
want to operate the VCR, press VCR1 on the remote control to put the remote in VCR mode.)
Chapter 2
25
Advertisement
Table of Contents
Troubleshooting
