Table of Contents
Advertisement
Connections
& Setup
Step 3: Configuring
for a VCR
1.
If your TV is connected
to a VCR, press OK.
If it is not, highlight
No and press OK (a screen will appear reminding
you
to connect ;,,our G-LINK cable to your TV and VCR.).
2.
Use the up and down arrow buttons
to highlight
the brand of your VCR that
is connected
to the TV and press OK.
i
_
.
,
,
If your brand
sn t hsted, highlight
Not Listedand
press OK.
3,
Tune your VCR to channel
02. Next, turn OFF your VCR. When you
complete
these steps, press OK to begin testing.
Important
Note: When code testing is in progress, don't touch your TV, VCR, or
any of the remote controls for these products.
4.
Look at the front display of your VCR. If your VCR turned on automatically
and changed
to channel
09, the test was successful. Highlight
Yesand
press OK.
If your VCR didn't change
to channel
09, you can either choose No or Test
this code again.
If you think your TV or remotes
might have been touched
during the test,
tune your VCR to channel
02, turn off your VCR and highlight
Test this
code again.
If you don't
think
the test was interrupted,
highlight
No. Tune
your VCR to
channel
02 and
turn offyour
VCR. Press OK (the GUIDE
Plus+ system
starts
testing
another
set of codes.)
Keep following
the previous
instructions
until the VCR finds the
correct
code.
18
Chapter
1
Advertisement
Table of Contents
Troubleshooting
