Programming The Remote; To Control A Vcr - GE 46GW945 User Manual

PrOgramming the Remote
_Theunivbrsalr6mote:banbe pr6grhmmed:tOCdntrol imost
brands of remote controllable VCRs and cable boxes.The
remote is already programmed to controlmost RCA, GE and
ProScan TVs VCRs, laserdisc _)laye_ hnd sate!lite receivers, '_
Other manufacturers' brands need to bepmgrammed. :
PrOgramming the Remote tO Control".
a VCR "
To determine whether the universal remote needs to be
programmed, turn the VCR on, point the remote at the VCR,
and press the VCR1 button. Then press POWER or CH ^
(channel up) or CH v (channel down) to see if the VCRresponds
to the remote commands. If not, the remote needs to be
programmed. _
i
- Follow these steps to program your universal remote to Control
your VCR:
! _, Turn on th.e VCR to be programmed,
2.• Look up your VC R brand and code number(s) on the code
list on the next page.
3. Press and hold the VCR1 button on the remote.
4. Enter the two-digit code from the code list.
.
.
Release VCR1 then press POWER to see if the VCR responds
to the remote commands. If it doesn't, try pressing VCR1
and POWER to see if the VCR responds.
Repeat these steps using the next code listed for your
brand, Until the VCR responds to the remotecommands.
You'll use these buttons when you:
program the remote to control any
devices.
This remote may not operate all
models of the brands that are shown.•
Use the codes shown at right or on
the sheet packed in with your
remote.
To program the VCR2,LD butt0nto
control a second VCR, follow these :
steps but use the VCR2ILD button
instead of the VCR1 button. _
i
26