Table of Contents
Advertisement
Using the Remote
Control
Using Direct Entry
1.
Turn
on the component
you want the remote
to operate.
2.
Look up the brand
and
code
nmnber(s)
for the component
on the code
list on page
26.
3.
Press and
hold
the component
button
that corresponds
to the component
you want
the
remote
to operate
(VCR1,
DVD, etc.)
4.
Enter
the code
from
the code
list.
5.
Release
the component
button.
6.
Press ON-OFF
to see if the component
responds
to the remote
commands.
If it doesn't,
try
pressing
the component
button
and
then
ONoOFF
again.
7.
If you get no response,
repeat
these
steps
using
the next code listed
for your brand
until
the
component
responds
to the remote
commands.
770
The buttons
might
operate differently
for
other components,
especially
when you're
using another
component's
menu
system,
How to Use the Remote After You've
Programmed
It
Once
the remote
has been
programmed
successfully,
you are ready
to use it to control
your
components.
To operate
the component:
1.
Press the component
button
(TV, VCR1,
VCR2,
DVD, AUX,
or SAT.CABLE)
to set the
remote
to operate
the component.
2.
Press
ON.OFF
to turn the component
ON or OFF.
3.
Use the remote
buttons
that apply to that component.
Note: If you keep pressing buttons
and nothing
happens,
the remote is probably in the wrong mode.
You must press the component
button that matches the component
you want to operate (i.e., if you
want to operate the VCR, press VCR1 on the remote control to put the remote in VCR mode.)
Chapter 2
25
Advertisement
Table of Contents
Troubleshooting
