Table of Contents
Advertisement
Using the TV's Features
You must use audio/video
cables to connect
your VCR to your TV in order for PIP to work.
.TV channel
•PIP
channel
(VID)_
from
VCR
PIP Troubleshooting
The PIP feature
on this TV only works if you connect
a second video source (like a
VCR or satellite receiver),
to your TV with audio/vldeo
cables. If you use a cable
box, you may need extra equipment.
Contact your cable company
and/or
go to
page 12 for more details about a cable box connection.
•
Swap won't work? Make sure the remote
is in the right mode.
For example,
once
you turn on the VCR with the VCR1 button,
you can't SWAP the pictures
until you
put the remote
in TV mode.Just
press the TV button.
•
No signal or bad reception?
Most VCRs and satellite receivers have an antenna
or
TV/VCR button.
Press the antenna
or TV/VCR button
on the front of the
component.
Note: If you programmed
the Universal remote control to operate your VCR, the
A?CTk)'¢NA button on the remote acts as a TV/VCR button.
•
Ever T time you change channels,
the same channel
appears
in both windows (the
main picture and the PIP picture).
A.
Press the CH CTRL button
on the remote
until the TV picture channel
number
is highlighted
(yellow). The channel
buttons
on your remote
control
won't work correctly
for PIP when the V/D channel
is highlighted
(yellow).
B.
The only way to successfully change channels
for the picture
that is coming
from the channel
on your VCR (the V!D channel),
is to press the channel
buttons
on the VCR or on the VCR's remote
control.
To change the PIP channel, press the
channel buttons on the VCR. To change
the TV channel, press CH CTRL until the
TV channel is highlighted
(yellow) and
press the CH up and down buttons.
With the auto tuning feature,
you can set
up the TV to tune to the channel you
need to watch by pressing that
component's
button.
Why You Should Use the Auto
Tuning Feature
The auto-tuning
feature automatically
tunes the TV to the correct channel for
different
components
you have connected
to your TV (like aVCR, DVD Player,
etc.) When you set up auto tuning in the menu system you don't have to
remember
to change your TV to channel
3, for example, when you want to
watch the tape in your VCR.
How to Set Up the Auto Tuning Feature
The way yon set up the auto tuning feature in the TV's menu corresponds
to
the component
buttons
on the remote and the way yoi_ have each component
connected
to your TV. When you set auto tuning, you're telling the TV what
channel
to tune to when you press the VCR1, VCR2, DVD, or SAT-CABLE
button on the remote control.
1.
Press MENU (the TVMAINMENUappears).
2.
Highlight
Channeland
press OK on your remote control.
3.
Highlight
Auto Tuningand
press OK.
38
Chapter 3
Advertisement
Table of Contents
Troubleshooting
