GE 13V110TD User Manual page 16

Chapter 1 Connections & Setup
3. Tune your VCR to channel 02. Next, turn OFF your VCR.
When you complete these steps, press OK to begin
testing.
Important Note: When code testing is in progress,don't touch your
TV/DVD, V CR, o r any of the remote con trois for theseproducts.
4.
Look at the front display of your VCR. If your VCR turned
on and changed to channel 09, the test was successful.
Highlight Yesand press OK.
If your VCR didn't change to channel 09, you can either
choose No or Test this code again.
If you think your 1V/DVD or remotes might have been
touched during the test, tune your VCR to channel 02,
turn off your VCR and highlight Test this code again.
If you don't think the test was interrupted, highlight No.
Tune your VCR to channel 02 and turn off your VCR. Press
OK (the GUIDE Plus+ system starts testing another set of
codes.)
Keep following the previous instructions until the VCR
finds the correct code.
Note: If the GUIDEPlus+ system can't locate the correct codefor
the VCR, a list of troubleshooting instructions appears to help you
before you try ogain.
TryVCRconfiguret ion again:repeat VCRsetup¸
Testalternate codes:testsselectedbrandsand if this
Fails,the test continues with all codesin the system.
5kip this step: the GUIDEPlus+ system won't be able to
scheduleprograms to recordon your VCR
Step 4: Confirming YourSettings
1. Make sure all settings are complete and correct. Highlight
Yes,end setup and pressOK. If your cable box and/or VCR
code testing failed, you should see INCOMPLETE where
the cable box and VCR codesare listed. Once setup is
complete, additional screens appear.
If any settings are incomplete or incorrect, highlight No,
repeat setup process and press OK. Follow the
instructions on the screen.
14
Graphics contained within this publication are for representation only.
Chapter 1