Table of Contents
Advertisement
PROBLEM:
The walking
belt is off-center or slips when walked on
SOLUTION:
a. If the walking belt is off-center,
first remove the
key and UNPLUG THE POWER CORD. If the
walking
belt has shifted to the left, use the hex
key to turn the left idler roller bolt clockwise 1/2 of a
turn; if the walking
belt has shifted
to the right,
turn the bolt counterclockwise
1/2 of a turn. Be
careful not to overtighten the walking belt. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is centered.
b.
If the walking
belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller bolts clock-
wise, 1/4 of a turn, When the walking belt is cor-
rectly tightened, you should be able to lift each side
of the walking belt 2 to 3 in. (5 to 7 cm) off the
walking platform. Be careful to keep the walking
belt centered. Then, plug in the power cord, insert
the key, and carefully walk on the treadmill for a
few minutes, Repeat until the walking belt is prop-
erly tightened.
PROBLEM:
The crosswalk
arms squeak during use
SOLUTION:
a. (Note: Correcting this problem requires a small
amount of white marine grease, available at hard-
ware stores.) Turn the Resistance Knob (88) coun-
terclockwise and remove it. Next, remove the
Resistance Cone (85) with the Crosswalk Arm
(82).
Apply a thin layer of white marine grease to the
outer surface of the Resistance Cone (85). Then,
reattach the Resistance Cone with the Crosswalk
Arm (82) and the Resistance Knob (88).
a
b
a
88
24
Hide quick links:
Advertisement
Table of Contents
