ProForm CROSSWALK 480 User Manual page 13

15. Insert the end of a Crosswalk Arm (82) into the
hole in the top of a resistance mechanism.
Make sure that the bend in the Crosswalk
Arm is positioned as shown.
Tighten the M4.2 x 19mm Screw (1) into the re-
sistance mechanism and Crosswalk Arm (82)
from the direction shown. Press a Small Cap
(13) into the hole for the Screw.
Attach the other Crosswalk Arm (82) as de-
scribed above.
15
Mechanism
16. Raise the Frame (57) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (54) so that the large
barrel and the Latch Knob (55) are in the posi-
tions shown.
Attach the upper end of the Storage Latch (54)
to the Frame (57) with a 3/8" x 1 3/4" Bolt (6)
and a 3/8" Jam Nut (5).
Attach the lower end of the Storage Latch (54) to
the Base (99) with a 3/8" x 1 3/4" Bolt (6). Note:
It may be necessary to move the Frame (57)
back and forth to align the Storage Latch with
the Base.
Lower the Frame (57) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
16
Large
Barrel
99
17. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see
pages 23 and 24).
13