ProForm CROSSWALK 480 User Manual page 10

.
Hold a Bolt Spacer (98) inside the lower end of
the Left Upright (79). Insert an M10 x 96mm Bolt
(7) with an M10 Star Washer (8) into the Left
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (98), M10 x 96ram
Bolt (7), and MIO Star Washer (8).
Orient the Left Upright Spacer (89) and the Left
Upright (79) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(99). Tighten the M10 x 96mm Bolts (7) until the
heads of the Bolts touch the Left Upright; do not
fully tighten the Bolts yet.
8
98
79
.
Press a Base Cap (91) into the Base (99).
With the help of a second person, tip the treadmill
so that the Base (99) is flat on the floor.
91
99
10. Set the console assembly face down on a soft
surface to avoid scratching the console assembly.
Identify the Right Handrail (100) which is
marked with a sticker. Hold the Right Handrail
near the console assembly. Attach the console
ground wire to the Right Handrail with a #8 x
1/2" Ground Screw (29).
Next, insert the console wire into the large hole
in the Right Handrail (100) and out of the top as
shown. Attach the Right Handrail with three
M4.2 x 19mm Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
Remove the ties from the two M8 Cage Nuts
(39). If necessary, press the Cage Nuts back
into place.
10
100
Console
Ground Wire_
Console
Assembl,
1 Console
Wire
1
• Large Hole
10