Table of Contents
Advertisement
TROUBLESHOOTING
Most treadmill
problems
can be solved by following
the steps below. Find the symptom
that applies, and
follow the steps listed. If further assistance
is needed, please see the back cover of this manual.
PROBLEM:
The power does not turn on
SOLUTION:
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 14), Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 14. IMPORTANT:
The treadmill
is not
compatible
with GFCl-equipped
outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
PROBLEM:
C.
Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch
protrudes as shown, the circuit breaker has
tripped, To reset the circuit breaker, wait for five
minutes and then press the switch back in.
The power turns off during
use
c
T ripped
Reset
SOLUTION:
a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the back cover of this manual.
PROBLEM:
The console displays
remain lit when you remove the key from the console
SOLUTION:
a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 19 to turn off the demo mode.
PROBLEM:
The displays
of the console do not function
properly
SOLUTION:
a. Adjust the incline level of the treadmill to 5 percent.
Remove the key from the console and UNPLUG
THE POWER CORD. With the help of a second
person, carefully tip down the Uprights (79, 80).
There may be two Screws (A) in the bottom of the
Belly Pan (78). If there are, remove them. Note: A
Phillips screwdriver with a shaft at least 5 in. (13
cm) long is required. Then, raise the Uprights.
I a
79
A
A
22
Hide quick links:
Advertisement
Table of Contents
