Shuffling Play Order; Tracks Introduction; Repeating Play Order; Playing And Loading Discs Simultaneously - RCA RP8075RS Information Manual

Shuffling Play Order
Select the SHUFFLE feature to randomize the
order of track play.
1. Press SHUFFLE to start random track play.
The display shows SHUFFLE in red to indicate
activation of shuffle mode.
2. Press SHUFFLE a second time to de-activate
the function.
Note: Shuffling tracks among discs depends on
the selected REPEAT mode. (see Repeating Play
Order)
Tracks Introduction
This feature is most useful for newly purchased
CDs. You can listen to the first ten seconds of
each track as brief introduction. In play mode,
press INTRO once, INTRO lights up at the
selected mode section on the display. To de-
activate, press INTRO again and the unit begins
playing tack 1 of the disc.
Repeating Play Order
You can repeat one track, one disc or all discs.
You can toggle between various modes.
Providing that the display shows ALL DISCS:
1. Press REPEAT once to play a specific track on
a particular disc over and over. The display
shows REPEAT 1.
2. Press REPEAT a second time and the display
shows REPEAT 1 DISC.With this mode
selected, the CD player plays the selected disc
repeatedly from start to finish.
3. Press REPEAT a third time, the display shows
REPEAT ALL DISCS. Selecting thismode sets
the init playing all loaded discs repeatedly.
Repeating a Program
When you program tracks into memory, you can
repeat playing the program by pressing REPEAT
after the program begins playing.
Playing and Loading Discs
Simultaneously
You can open the CD compartment tray without
interrupting the playing music. Simply press
OPENICLOSE once to slide out the tray. While
the disc is playing, you can change the rest of
the four discs by pressing DISC SKIP to rotate
the tray clockwise and anti-clockwise to load
and unload CDs. Press OPEN/CLOSE again to
close the tray. To play or select disc, refer to the
section on Playing Discs.
Programming Play Order
You must be in Stop mode to program/store
your desired track sequence.
1. Press PROGRAM.
2. Press DISC SKIP or one of the Disc Direct
Access buttons to choose a disc.
3. Press I<l<l or _ to choose a track.
4. Press PROGRAM to save the selected track
number into memory.
5. Repeat the above steps 2 to 4 for
programming up to 32 tracks.
6. Press PLAY/PAUSE to begin programmed
play.
Recalling and Editing the
Program
You must be in Stop mode in order to recall and
edit the program.
1. Press PROGRAM to enter Program mode.
2. Press PROGRAM to the next program
number until you get to the programmed
track you want to change.
3. Press DISC SKIP to choose the disc and then
press _ or _ to choose a
replacement track.
4. Press PROGRAM to change the current
programmed track to the one youjust
selected.
Playing the Program
To play your programmed tracks, press
PROGRAM then PLAY/PAUSE.
Clearing the Program
You cannot select tracks within a program to
clear. Upon completion of the following steps,
the entire program will be cleared.
1. Press PROGRAM to enter Program mode.
2. Press and hold the STOP button until CLEAR
shows in the display. If the program is
already empty, EMPTYwill show in the
display.
8_
RP8075RS IB 9 7/20100, 5:01 PM