Troubleshooting Tips; Care And Maintenance - RCA RP8075RS Information Manual

Problem
Solution
CD Player doesn't turn on
No sound
CD Player doesn't play
CD sound skips
Remote control doesn't work
Make sure power cord is securely plugged into the AC power
outlet.
Unplug the unit for a moment, then plug it back in.
Check the outlet by plugging in another device.
Ensure that a disc is loaded on the CD compartment tray.
Adjust volume setting.
Check for proper connection of cables between speakers and
amplifer and CD player.
Make sure volume is not muted. To de-activate, press MUTE on
the remote control.
Make sure the tray contains at least one disc.
Make sure that discs' labels are facing up.
Make sure that Pause mode is not activated.
Clean the disc (refer to Care and Maintenance).
Check disc for warping, scratches, or other damage.
Ensure that the CD player is placed on a solid and level surface.
Check for vibartions or shock that may affect the CD player.
Move the CD player to another location if necessay.
Make sure the CD player is plugged into a working AC outlet.
Make sure that the batteries are correctly installed in the
remote control.
Replace weak batteries (DO NOT mix old batteries with fresh
ones, it can cause damage to the remote control).
Point the remote directly at the front of the unit when pressing
the buttons.
Move closer to the CD player with the remote control.
Make sure that there are no obstacles between the remote and
the unit.
Cleaning the Exterior
Disconnect the system from AC power before
cleaning the exterior of the system with a soft
clean cloth.
Handling Compact Discs
• Do not touch their signal surfaces. Hold by
the edges, or by one edge and the hole.
• Do not affix labels or adhesive tape to the
label surfaces. Also, do not scratch or
damage the label.
• Discs rotate at high speeds inside the player.
Donot use damaged (cracked or warped)
discs.
Cleaning Compact Discs
• Dirty discs can cause poor sound quality.
Always keep discs clean by wiping them
gently with a soft cloth from the inner edge
toward the outer perimeter.
• If a disc becomes very dirty, wet a soft cloth
in water, wring it out well, wipe the dirt
away gently, and then remove any water
drops with a dry cloth.
• Do not use record cleaning sprays or
antistatic agents on discs. Also, never clean
the discs with benzene, thinner, or other
volatile solvents which may cause damage to
the disc surface.
12
RP8075RS IB 13 7/20100, 5:02 PM