RCA RP8085 User Manual

RCA RP8085 User Manual

5 disc changer cd player
Hide thumbs Also See for RP8085:

Advertisement

÷
÷
This device generates and uses radio frequency
(RF)energy, and if not installed and used properly, this
equipment may cause interference
to radio and television reception.
This equipment
has been type tested and found to comply with the specifications in Subpart J of Part 15 of FCCRules.
These rules are designed to provide reasonable protection
against radio and television
interference
in a residential installation.
However, there is no guarantee that interference
will not occur in particular
installations.
If this equipment
does cause interference
to radio or television reception (which you can determine
by
turning the equipment
off and on), try to correct the interference
by one or more of the following
measures:
• Reorient the receiving antenna (that is, the antenna for the radio or television
that is "receiving"
the interference).
• Move the unit away from the equipment
that is receiving interference.
• Plug the unit into a different
wall outlet
so that the unit and the equipment
receiving interference
are on different
branch circuits.
If these measures do not eliminate the interference,
please consult your dealer or an experienced
radio/television
technician for additional
suggestions.
Also, the Federal Communications Commission has prepared a helpful booklet, "How To Identify and Resolve Radio TV
Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington, DO 20402. Please
specify stock number 004-000-00345-4 when ordering copies.
For Your
Safety
The AC power plug is polarized (one blade is wider than the other) and only fits into AC power
_:__
outlets one way. If the plug won't go into the outlet completely, turn the plug over and try to insert
it the other way. If it still won't fit, contact a qualified electrician to change the outlet, or use a
different
one. Do not attempt
to bypass this safety feature.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
For Your
Records
In the event that service should be required, you may need both the model number and the serial number. In the space
below, record the date and place of purchase, and the serial number:
Model No. RP8085
Remote Control No.
Date of Purchase
Place of Purchase
Serial No.
Service
Information
This product should be serviced only by those specially trained in appropriate
servicing techniques. For instructions on
how to obtain service, refer to the warranty included in this Guide
WARNING
: TO PREVENT
FIRE OR ELECTRICAL
SHOCK HAZARD,
DO NOT
EXPOSE THIS PRODUCT TO
RAIN OR NOISTURE.
s EE M_RX_,_; ,:,NSO_T, M/S_,,,K , F P_ODUCT
÷
RP8085 IB
1
_
4/5/00, 9:49 AM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RP8085 and is the answer not in the manual?

Questions and answers

Summary of Contents for RCA RP8085

  • Page 1 ÷ This device generates and uses radio frequency (RF)energy, and if not installed and used properly, this equipment may cause interference to radio and television reception. This equipment has been type tested and found to comply with the specifications in Subpart J of Part 15 of FCCRules. These rules are designed to provide reasonable protection against radio and television interference...
  • Page 2: Table Of Contents

    ÷ FCC/Safety Information Using the Remote Control ......... First Things First ....Unpack the System ......Troubleshooting Tips ..13 Check for Moisture ......Choose a Location ......Care and Maintenance ..13 Connections ......Index ........Connecting the CD player to an amplifier .........
  • Page 3: Control

    ÷ _!_:: L.._ I _iJo_o_ I o/o0 ol_:-_o_ __-4 [][]_ _ I CONGRATULATIONS YOUR PURCHASE... Congratulations on the purchase of your new 5 Avoid locations that are subject to moisture, DISC CHANGER CD PLAYER! mechanical vibration, shock, or excessive ÷ ÷...
  • Page 4: Connections

    ÷ White L //Red Digital Out (Optical) Connecting CD Player to an amplifier 4. If your amplifier is equipped with optical Prior to or during connections, the CD player ÷ ÷ input, connect it with an optical cable (not should NOT be plugged to an AC power outlet. supplied, available at general audio shops) to 1.
  • Page 5: General Controls

    ÷ Main Unit REPEAT POWER/STANDBY Press this button to turn the player on and off. You can set the CD player to play repeatedly a (Note: The unit will automatically switch to track, a disc or all discs. Press REPEAT to toggle between these modes: REPEAT, REPEAT 1, standby mode without any key acitvation for 30 minutes after unit is turned on.)
  • Page 6: Messages

    ÷ Selected Mode Music Calendar Playing Disc CD Message Display/Track Time/Track Number Fig. 1 Vacuum Fluorescent Display CD TITLE Vacuum Fluorescent For inputting CD titles. Display (VFD) messages As you select various modes, the VFD shows the CLEAR settings and current status of the unit. Fig.1 ÷...
  • Page 7: Remote Control

    ÷ Remote Control You can control or adjust most of the function keys as those are present on the main unit through the remote control. However, the following keys are present on the remote control only: REVERSE/FORWARD In play mode, press and hold to start reverse or forward search operations.
  • Page 8: Using The Cd Player

    ÷ Elapsed Time Disc Number (flashes) Track Number Track Number (flashes) Fig. 2 ÷ ÷ Playing Discs This section contains a set of step-by-step procedures on how to use your new 5 DISC CD CHANGER PLAYER.Press POWER to turn on the Press PLAY, now you can select a disc by unit, the display will show the "NO DISC"...
  • Page 9: Shuffling Play Order

    ÷ the four discs by pressing DISC SKIP to rotate Shuffling Play Order the tray clockwise and anti-clockwise to load Select the SHUFFLE feature to randomize the and unload CDs. Press OPEN/CLOSE again to order of track play. close the tray. To play or select disc, refer to the 1.
  • Page 10: Using Ats (Auto Track Skip)

    ÷ Fig. 3 Using Auto Track Skip Clearing the ATS Program Clearing the ATS program is also a lot like (ATS) clearing a regular program. 1. PressATS. ATS is the opposite of programmed play. Rather 2. Pressand hold CLEAR until CLEAR shows on than programming into memory the tracks that the display.
  • Page 11: Erasing Cd Titles

    ÷ programming by yourself to be recorded on Erasing CD Titles side B of the cassette tape. (Note: when For single disc: playback ends for recording on side A of 1. Press CD TITLE to activate the feature. "CD cassette tape, the unit will pause playback TITLE"...
  • Page 12: Cd Display Messages

    ÷ CD Display Messages When using the CD function, you may encounter the following messages: CD compartment tray is in. riPE,,, I_ I CD compartment tray is out. Program is full (applies to both Program and ATS mode). ,-q_,, , ,,, ,_-, I_1 I- Reading disc's table of contents (how many tracks there are and the total time for the disc).
  • Page 13 ÷ Open the battery compartment lid. Insert 2 AAA-size batteries with the correct polarities by following the engraved diagram in the compartment. Replace and close the lid. Refer to the description of the remote control on page 6. Now you can operate the unit from a distantr "...don't point, it's rude!"...
  • Page 14: Troubleshooting Tips

    ÷ Problem Solution CD Player doesn't turn on Make sure power cord is securely plugged into the AC power outlet. Unplug the unit for a moment, then plug it back in. Check the outlet by plugging in another device. No sound Ensure that a disc is loaded on the CD compartment tray.
  • Page 15 ÷ & AC power outlet 3 Open/close 4 Amplifier 3 Assigning CD titles and play order 9 ATS (Auto Track Skip) 4 Auxiliary 3 PHONES (jack) 5 Phones level 5 PLAY/PAUSE 4, 6 Playing discs 7 Cables 2,3 Polarized Plug 3 Care and maintenance POWER 4, 6 CD display messages 10...
  • Page 16: Us Warranty

    ÷ What your warranty cover: Any defect in material or workmanship. For how long after our purchase: • One year. (The warranty period for rental units begins with the first rental or 45 days from date of shipment to the rental firm, whichever comes first.) What we will do: •...
  • Page 17: Canadian Warranty

    ÷ Thomson Consumer Electronics Canada, Inc. warrants to the purchaser or gift recipient that if any manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation. This warranty does not include damage to the product resulting from accidents misuse or leaking batteries.

Table of Contents