Shuffling Play Order; Tracks Introduction; Repeating Play Order; Playing And Loading Discs Simultaneously - RCA RP8085 Manual

Using the CD Player

Shuffling Play Order

EN
Select the SHUFFLE feature to randomize the
order of track play.
1. Press SHIFT and then SHUFFLE (numerical
key 9) to start random track play. The display
shows SHUFFLE to indicate activation of
shuffle mode.
2. Press SHIFT and then SHUFFLE a second time
to de-activate the function.
Note: MIX for Thomson model.
Note: Shuffling tracks among discs depends on
the selected REPEAT mode. (see Repeating Play
Order)

Tracks Introduction

This feature is most useful for newly purchased
CDs. You can listen to the first ten seconds of
each track as brief introduction. Press INTRO
once, INTRO lights up at the selected mode
section on the display. To de-activate, press
INTRO again and the unit begins playing track 1
of the disc.

Repeating Play Order

You can repeat one track, one disc or all discs
and toggle between various modes. Providing
that the display shows ALL:
1. Press REPEAT once to play a specific track on
a particular disc over and over. The display
shows REPEAT.
2. Press REPEAT a second time and the display
shows REPEAT 1. With this mode selected,
the CD player plays the selected disc
repeatedly from start to finish.
3. Press REPEAT a third time, the display shows
REPEAT ALL. Selecting this mode sets the
unit playing all loaded discs repeatedly.
Repeating a Program
When you program tracks into memory, you can
repeat playing the program by pressing REPEAT
after the program begins playing.
Playing and Loading Discs
Simultaneously
You can open the CD compartment tray without
interrupting the playing music. Simply press
OPEN/CLOSE once to slide out the tray. While
the disc is playing, you can change the rest of
8
the four discs by pressing DISC SKIP to rotate
the tray clockwise and anti-clockwise to load
and unload CDs. Press OPEN/ CLOSE again to
close the tray. To play or select disc, refer to the
section on Playing Discs.

Programming Play Order

You must be in Stop mode to program/store
your desired track sequence.
1. Press PROGRAM.
2. Press DISC SKIP or one of the Disc Direct
Access buttons to choose a disc.
3. Press Numerical Keys or NEXT/ PREV to
choose a track.
4. Press OK to save the selected track number
into memory.
5. Repeat the above steps 2 to 4 for
programming up to 32 tracks.
6. Press PLAY/PAUSE to begin programmed
play.
Recalling and Editing the
Program
You must be in Stop mode in order to recall and
edit the program.
1. Press PROGRAM to enter Program mode.
2. Press OK to the next program number until
you get to the programmed track you want
to change.
3. Press DISC SKIP or Direct Disc Access keys to
choose the disc and then press NEXT / PREV
or Numerical Keys to choose a replacement
track.
4. Press OK to change the current programmed
track to the one you just selected.
Playing the Program
To play your programmed tracks, press
PROGRAM then PLAY/PAUSE.
Clearing the Program
You cannot select tracks within a program to
clear. Upon completion of the following steps,
the entire program will be cleared.
1. Press PROGRAM to enter Program mode.
2. Press and hold the CLEAR button until
CLEAR shows in the display.